Veneer Dryer For Plywood-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

We are pleased to announce that the double-layer veneer dryer recently customized for a Thai customer has been completed and is being prepared for shipment.

Recently, the 2 deck dryer ordered by our customers has been completed and is ready for delivery. It is equipped with a biomass burner and can directly burn bark. The output can reach 80 cubic meters. It is used to dry rubber wood veneers. Before placing an order, the customer went to another customer's site for a field inspection and was very satisfied with the equipment. After that, he decided to purchase it.

We are pleased to announce that Shine has successfully reached an important agreement with our European customer, who has ordered a new high-capacity roller veneer dryer. This roller dryer is equipped with a fully automatic board loading and unloading system, which is customized for the customer's needs. It not only improves production efficiency, but also reduces labor costs and ensures uniform drying of veneer.

Daily maintenance of veneer dryer1. During normal use,the lubricating oil should be replaced after the fan runs for 72 hours to ensure the normal operation of the fan.2. When starting the equipment,it should be heated first,and then the fan should be turned on.We can't just heat without turning on the fan.3. If the heat sink is blocked by foreign matter,it should be cleaned in time, otherwise the heat transfer will be affected.4.

Recently, our company's 2 deck veneer dryer in Cambodia was successfully installed and put into operation. With the growing demand for veneer processing, Thailand customers need a set of efficient and stable drying equipment to expand production. After several rounds of technical exchanges and program evaluations with our company, the customer finally chose our 2 deck veneer dryer.

Veneer dryer is one of the main equipment in the production process of veneer and plywood, and the drying quality of veneer directly affects the quality of veneer and plywood products. The principle is that the veneer is preheated and dried under the clamping of the upper and lower two coils, and the coil is heated by steam or heat conduction oil to transfer the temperature to the veneer.

Veneer dryer precautionsDo not put a lot of veneers at once, in the use of veneer dryer for drying work, pay attention to not in order to save trouble at once placed too much veneer. This situation will affect the drying effect of the veneer, causing a certain degree of damage to the equipment.2. Place the veneer to ensure uniformity, in order to ensure that the drying effect of the veneer is good, in the placement of the veneer, it is recommended to place the thickness of uniformity, size of the same size of the veneer, so as to ensure the quality of veneer drying to a large extent.3.

Veneer dryer has now launched energy saving and emission reduction, and the energy consumption problem of material boring is becoming more and more serious, but if we can improve the power utilization rate of the boring process, we can save a lot of power every year. Air source heat pump boring is a new energy-saving boring skill developed in this case, with low energy consumption, low environmental pollution, high boring quality, wide range of applications.

Great news that the four deck roller veneer dryer starts the installation with our engineer's arrival and guidance. Our romania customer arranges 6-10 workers to help install this dryer heate by the thermal oil.