Wood Veneer Dryer Line-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Because the single board dryer is a long and large equipment, it is necessary to install the single board dryer in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

Recently, the veneer dryer provided by our company was successfully installed in Cambodia and has been put into use. Our engineers go to the customer's factory to guide the installation and will not return until the equipment is running normally and the workers are skilled in operation.The high reliability and low failure rate of veneer drying equipment greatly reduces equipment maintenance and downtime, and improves the overall operating efficiency of the production line.

Recently, our new customer successfully installed and put into use the 2 deck veneer dryer provided by our company. During normal operation, the veneer dryer has successfully completed the efficient drying of rubber wood veneers. Normal drying of rubber wood veneers can be dried to zero water, and the drying effect is satisfactory. It not only greatly improves the production efficiency of veneer processing, but also shows great advantages in environmental protection and energy saving.

Because the veneer dryer machine is a long and large equipment, it is necessary to install the veneer dryer machine in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

Recently, a brand new veneer dryer from our company is being sent to the customer's factory. After many inspections, the customer finally chose us. We specially customize the production according to the customer's veneer size to ensure that the output of the veneer dryer meets the customer's production needs. It can be used to dry various wood species.

Choose the regular veneer dryer manufacturer's equipment, in order to ensure the quality of wood after drying.

Wood veneer needs to be dried before use, so that the wood is not prone to problems in future use, and the dried sheet is easier to save.

Are you worried that the output of the veneer dryer you bought cannot reach the output? Or have you already purchased it but the expected output has not been achieved? The main reasons are as follows:First: the type of wood to be dried. Some special woods will take longer to dry.Second: the initial moisture content and final moisture content of the dried veneer.

     The products can also be used as other tunnel wood drying equipment, especially suitable for wood with an initial moisture content of about 28% and a moisture content of 10-8%, which can dry the wood in a short period of time, and can also dry the wood crafts, decorations and special standard wood.     The dehumidification working principle of the veneer dryer is to use the unsaturated wet air to dry the wood to absorb the moisture in it, and at the same time, in order to improve the moisture absorption of the wet air, the moisture is heated first.