Working Process Of Mesh Belt Dryer Machine-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Dear Customers and Friends,We are here to announce that we are going to have one day off as a result of the "Tomb Sweeping Festival". We will resume working on Thursday. 

     The products can also be used as other tunnel wood drying equipment, especially suitable for wood with an initial moisture content of about 28% and a moisture content of 10-8%, which can dry the wood in a short period of time, and can also dry the wood crafts, decorations and special standard wood.     The dehumidification working principle of the veneer dryer is to use the unsaturated wet air to dry the wood to absorb the moisture in it, and at the same time, in order to improve the moisture absorption of the wet air, the moisture is heated first.

Because the single board dryer is a long and large equipment, it is necessary to install the single board dryer in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

Faults of the board dryer are as follows: 1. Failure analysis of rotary granulator: the main engine current is unstable. Production reasons: uneven feed, main motor bearing damage or poor lubrication, no heating. Faulty heater or incorrect phase, incorrect screw adjusting pad, component interference. Treatment method: Troubleshooting, check the feeder, replace the bearing if necessary. Repair the main motor and replace the heater if necessary. Check whether each heater is working properly, pull out the screws to check the interference of the screws, and check the adjustment pad. 2.

Because the veneer dryer machine is a long and large equipment, it is necessary to install the veneer dryer machine in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

The first choice of leather dryer with energy-saving green environmental protection environment air energy heat pump heat source wood drying skills the heat source part of the equipment is a high temperature air energy heat pump. 2. The heat pump host equipped with the kiln type loading capacity absorbs and uses the heat in the air to condense and vaporize into a high temperature working medium of 95-105℃ under the work of the compressor, and uses the zhuanli thermal insulation copper pipe to transmit the heat to the condenser in the kiln to heat the air in the kiln.

The veneer dryer is one of the main equipment in the production of veneer, and the quality of veneer drying directly affects the quality of veneer and glued products. The hot air roller continuous rolling design is based on the most advanced continuous pressure contact veneer drying technology in the world.

First, the heating speed is fast. Microwave heating of veneer dryer is completely different from traditional heating. This is the process by which the heated material itself becomes a heater with no heat conduction. Therefore, although it is a material with poor thermal conductivity, it can also reach heating temperature in a very short time.Two, energy saving and high efficiency.

The 2024 World Forestry Congress will be held in Nanning from November 23 to 25, 2024. As an exhibitor of the Guangxi Nanning Forestry Congress, Shine sincerely invites you to visit our booth to discuss the infinite possibilities of future development!Booth number: D8 Hall 807+808Time: November 23-25, 2024Location: Nanning International Convention and Exhibition Center, GuangxiThe 2024 World Forest Industry Conference will be themed "Green Forest Industry, Cooperation and Sharing - Innovation Leading High-quality Development of Forest Industry".