Wood veneer needs to be dried before use, so that the wood is not prone to problems in future use, and the dried sheet is easier to save. Here's a look at how the dryer works.Wood veneer into the dryer before, after treatment, divided into the same thickness of the plate, into the mechanical
2024/04/29 14:41
1, prevent wood deterioration and decay, extend the life of wood products.Wet wood stacked in the outdoor air for a long time, if no corresponding treatment measures are taken, it is easy to cause rot and insect pests. Reducing the moisture content of wood to less than 20% can greatly reduce the
2024/04/29 14:33
1, prevent wood deterioration and decay, extend the life of wood products.Wet wood stacked in the outdoor air for a long time, if no corresponding treatment measures are taken, it is easy to cause rot and insect pests. Reducing the moisture content of wood to less than 20% can greatly reduce the
2024/04/28 17:25
Rotary cutting veneer dryer equipment has the characteristics of fast and monotonous, good uniformity, high energy efficiency ratio, small footprint, no environmental pollution, etc., can be widely used in various wood drying treatment. Equipped with infrared temperature measurement, low noise
2024/04/28 17:17
1. Multi-band automatic temperature control, high temperature alarm, humidification, moisture drainage, punctual switching machine, suitable for wood secondary drying, balance wood moisture content.2. Fast heating, uniform heating, less heat loss, can be combined disassembly, easy to move, suitable
2024/04/27 15:09
The rotary veneer dryer is used for drying wood, which has the advantages of energy saving, reliability, short cycle, high quality and low cost. Widely used in all kinds of wood processing enterprises, especially suitable for wood products export enterprises. HGG series drying equipment, during
2024/04/27 15:04
        The veneer dryer is required to transfer heat and quality together during the drying process to ensure that the wet vapor partial pressure (concentration) on the surface of the material is higher than the wet vapor partial pressure in the external space, and that the heat source temperature
2024/04/25 17:46
            The drying rate of the material in the veneer dryer equipment depends on the surface evaporation rate and the dispersion rate of the internal wet separation. Generally, the drying rate in the early drying stage is controlled by the surface vaporization rate. Then, as long as the
2024/04/25 17:39
Veneer dryer is one of the main equipment in the production process of veneer and plywood, and the drying quality of veneer directly affects the quality of veneer and plywood products. The principle is that the veneer is preheated and dried under the clamping of the upper and lower two coils, and
2024/04/18 14:39
1. Experienced users know that when using the dryer, the speed limit of the drum is not very low, which can improve the contact number of materials and hot air, thereby improving the drying efficiency of the dryer.2. The combination of countercurrent dryer drying should be used to avoid some water
2024/04/18 14:09
Veneer dryer precautions1. Do not put a lot of veneers at once, in the use of veneer dryer for drying work, pay attention to not in order to save trouble at once placed too much veneer. This situation will affect the drying effect of the veneer, causing a certain degree of damage to the equipment.2
2024/04/17 17:37
How to improve drying speed in a veneer dryer:Firstly, increase material lifting devices within the veneer dryer according to actual production needs to expand heating area and enhance heat exchange conditions for increased output.Secondly, particle size also affects drying efficiency; reducing raw
2024/04/17 17:30