Veneer Dryer In Drying Wood Need To Pay Attention To Some Problems

The wood veneer dryer needs to pay attention to some problems when drying wood. Before use, it should start the heating fan and start the speed regulating motor when reaching the drying temperature. The veneer should be entered longitudinally from the feed port, the feed should be straightened, the veneer and the drive roller into a 90 degree feed connection, before drying the veneer should be cut neatly. Drying should master the moisture content, according to the moisture content of the board, adjust the speed of the motor.

Precautions for operation of wood veneer dryer

1. When the wood dryer enters the scene, it must be connected by professionals. The horizontal error of the installation foundation should be controlled within plus or minus 3mm.

2, the longitudinal veneer dryer from the inlet into the machine, the import into the material to straighten, so that the veneer and the transmission roller into 90° into the material connection is better, veneer should be cut neatly before drying in order to avoid traffic jam.

3. After drying, the veneer should strictly master the water content, and adjust the speed of power according to the water content of the user's drying veneer. The temperature of the board dryer below 0.6mm should be between 110C and 130C, the number of revolutions should be controlled between 1000 RPM and 1200 RPM, the thickness of the board is above 0.8mm, the temperature of the dryer should be between 150C and 170C, and the speed is 800 RPM 1 min to 900 RPM. The normal water content is 8~10 water.