Pine is considered one of the most difficult woods to dry, mainly due to its wood structure and composition.1. Uneven density: Pine fibers are relatively fine and soft, resulting in uneven density inside the wood. This makes the wood dry at an inconsistent rate, prone to cracking and warping.2.…
2024/08/29 15:13
The hardness of wood is mainly affected by factors such as wood species, density and moisture content. However, the following treatment methods can increase the hardness of wood:Heat treatment: Heat treatment is a method of changing the physical and chemical properties of wood by heating it. This…
2024/08/28 10:29
Recently, the 2 deck veneer dryer purchased by a Thai customer was installed and tested. Our engineers guided the installation and trained the workers until the equipment was running normally. The veneer dryer is equipped with a biomass burner, which can directly burn the bark, saving fuel costs.…
2024/08/22 14:14
The WMF International Woodworking Exhibition will be held from September 11 to 14, 2024. Shine sincerely invites you to visit our booth!Booth number: 7.1D72Time: September :11-14, 2024Location: National Exhibition and Convention Center (Shanghai Hongqiao)During the exhibition, you will gain:…
2024/08/20 14:16
Recently, the 2 deck veneer dryer purchased by our customers has been installed. Our engineers went to guide the installation and will return only when the equipment is operating normally. Equipped with a biomass burner, it can directly burn bark to save fuel costs. We welcome customers to visit…
2024/08/15 14:05
Are you worried that the output of the veneer dryer you bought cannot reach the output? Or have you already purchased it but the expected output has not been achieved? The main reasons are as follows:First: the type of wood to be dried. Some special woods will take longer to dry.Second: the initial…
2024/08/14 15:21
One of our Thai customers asked his consultant to visit our factory on the weekend. During the visit, the customer asked questions about some technical issues such as the operating principle and internal structure of the vertical dryer. Our sales manager answered them one by one and saw the…
2024/08/08 14:28
1. Heat exchange systemShine heat exchanger adopts step-by-step heat exchange. The specifications of each section of the heat exchanger are different, and the hot air in the heat exchanger can be evenly distributed to the veneer. The moisture content of the dried veneer is uniform, flat, without…
2024/07/31 14:19
Now our engineers have gone to the customer's factory to install the drying equipment. This is the second veneer dryer purchased by the customer, and the customer is very satisfied with the equipment. It is equipped with a biomass combustion furnace (can be equipped with other heat sources), which…
2024/07/26 10:55
The 2 deck roller veneer dryer with biomass burner purchased by Malaysian customers is currently in operation. It is used to dry rubber wood. We welcome you to visit the site. The new axial flow fan is used to reduce power consumption, saving energy and electricity for you. The heat exchange is…
2024/07/24 10:13
A 2 deck veneer dryer ordered by our Vietnamese customers is ready for shipment. It uses a new axial flow fan, which reduces the power of the whole machine by 38%, saving energy and electricity for you. It uses a biomass burner for heating, which can directly burn the bark, and the dried boards are…
2024/07/19 09:51
Many people do not know how to maintain the veneer dryer to extend its service life. Shine will show you how to maintain the dryer regularly.1. Clean the inside and outside of the dryer regularly to ensure good ventilation and smooth hot air flow.2. Check the connections and components of the…
2024/07/17 10:17