Introduction to veneer dryer

The rotary veneer dryer is used for drying wood, which has the advantages of energy saving, reliability, short cycle, high quality and low cost. Widely used in all kinds of wood processing enterprises, especially suitable for wood products export enterprises. HGG series drying equipment, during normal operation, the fuel is fully burned in the combustion room, and the heat exchange system generates high temperature air. Under the effect of circulating fan, the high temperature air is transported to the drying room through the control pipe system to dry the wood, and a lot of atmospheric pressure steam is generated in the steam generation system, which is sent to the drying room through the control pipe system according to the requirements of the drying process. When the wood is sprayed and humidified, the full steam can make the moisture inside and outside of the wood common in a short time, and then relieve the residual stress of the wood.

At the same time, our company's pressure continuous heating drying process can be used for solid and heavy wood, which solves the defects such as internal cracking, end cracking and deformation of wood in the drying process, and improves the wood yield. And equipped with heat energy secondary utilization system, reduce the heat energy loss caused by drainage, reduce the drying cost, shorten the drying cycle. When the moisture content of the wood is less than 15%, after 6-8 hours of high temperature dry steaming, all the borers and eggs parasitic in the wood can be killed. Welcome customers to visit and negotiate.